|
[Sponsors] |
December 4, 2009, 05:47 |
NEW surface tension model for Fluent
|
#1 |
New Member
Join Date: Mar 2009
Posts: 15
Rep Power: 17 |
Hello there!
I have made a new surface tension model. It gives no spurious currents within the volume of secondary phase, but there is always spurious velocity in one or two cells on interface. This velocity is increasing with time. What is it caused by? I think I should make a change to pressure correction equation, but I am afraid that it is not possible in Fluent. right? Please, any advice! best regards bohis |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Continuum Surface Force Model | Miguel | Main CFD Forum | 4 | August 4, 2012 14:56 |
Surface tension problem. | Kes | FLUENT | 0 | May 19, 2008 22:49 |
Surface tension - Continuum Surface Force model | Robert | Main CFD Forum | 0 | May 2, 2002 07:34 |
surface tension model in EX26 | Junhua Wu | FLUENT | 0 | June 7, 2000 10:49 |