|
[Sponsors] |
January 12, 2010, 10:37 |
Problem with Injection in engine Cylinder
|
#1 |
New Member
Join Date: Oct 2009
Posts: 26
Rep Power: 16 |
Hello,
I am trying to inject fuel into the engine cylinder. I have done some calculations and tried to input it into fluent but the simulation does not reveal correct results. The problem is that even after changing the mass flow rate (Even by increasing it 10 times), the flow doesnt come fully inside the cylinder. It just comes upto a very short distance. I am injecting it with pressure of 200 bar so, the injection time should not be a problem. Can anyone also suggest which injection module (Like Single, surface.. etc) will be the correct one for this purpose Any suggestions and help are highly welcomed Thank you all in anticipation |
|
Tags |
injection |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3-d mesh gambit (cylinder within a cylinder) | Jason | ANSYS Meshing & Geometry | 29 | October 30, 2015 08:59 |
meshing of two-stroke engine in gambit | ravi | FLUENT | 2 | January 18, 2012 01:14 |
solving airfoil like square cylinder problem? | zonexo | Main CFD Forum | 1 | May 27, 2006 15:16 |
mass injection in a 2D axi-symmetric problem | hyun | Main CFD Forum | 1 | April 26, 2006 00:25 |
KIVA3V2R injection problem | Jeffery | Main CFD Forum | 0 | April 21, 2006 17:21 |