|
[Sponsors] |
![]() |
![]() |
#21 |
New Member
majid
Join Date: May 2011
Posts: 3
Rep Power: 14 ![]() |
hi,
I am preparing a job in the si cylinder but i don't have the 3d geometry for simulate them in fluent i can't found it any were. please if you can help ! |
|
![]() |
![]() |
![]() |
![]() |
#22 |
New Member
Mohab Gad
Join Date: Jan 2013
Posts: 2
Rep Power: 0 ![]() |
Hi all;
Am working at 3D dynamic mesh inside a cylinder and am using inlet and outlet ports am always getting negative volume i am using remeshing, layering and smoothing i tried to defined the port as interface, change the zone type and even copy the BC i always get nothing am starting from BDC i don't know what to do any more ...... can anyone help please. ![]() |
|
![]() |
![]() |
![]() |
Tags |
remeshing |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Some questions about mesh updating in dynamic mesh technique | lzgwhy | Main CFD Forum | 0 | June 14, 2009 08:01 |
dynamic mesh prob inside the cylinder | kantharao | FLUENT | 0 | May 30, 2008 06:36 |
Cannot preview the dynamic mesh | sam | FLUENT | 4 | May 26, 2005 06:58 |
Help: Is it possible to use dynamic mesh model and | Valery Ponyavin | FLUENT | 1 | September 20, 2003 14:18 |
Dynamic mesh & Multiphase | Alexandre | FLUENT | 3 | September 13, 2002 11:35 |