|
[Sponsors] |
March 28, 2010, 12:41 |
Yplus and CP diagrams acceptable?
|
#1 |
Member
smith
Join Date: Apr 2009
Posts: 75
Rep Power: 17 |
Hello everyone.
im doing a 3d simulation at the moment and because of problems i meshed my geometries without an boundary layer. i provided a plot of yplus and a plot of the contours of pressure. as you can see, my yplus is roughly in the range of 50-500. my question is now, these diagrams are full of data points, i guess thats because of the rough distribution of the mesh elements over the geometry surface? But is this affecting the accuracy of my results? if so, how much? are they totally wrong now? |
|
|
|