Surface Points

Supersonic · April 19, 2016, 14:26

I did, but that only works for that specific case. I was hoping I could do it for one case, save it, and then copy and modify the case in Design Modeler. Thanks for the advice.

Supersonic · April 19, 2016, 15:02

Hi Chris,
Thank you for this post, it was very helpful! I have used this to create my 100 surface points. Now I have 3 quick questions.

1. When I do this it says "Warning : point creation failed" but when I "manage" my points, I can see them all there. Do you know why it is doing this?

2. Is there a way to check to make sure they are all in the correct place?

3. Is there a way to automatically (with code like before) group my points together into different groups?

Thank you very much for the help!

aeroramji@gmail.com · April 26, 2017, 02:08

Hi everybody,

I am simulating heat transfer problem in a rectangular duct for which I need to create more than 200 iso-surfaces.

When I change the Reynolds number and run the simulation, I am supposed to create the same 200 iso-surfaces.

Is there any way to use a set iso-surfaces created in one fluent to another fluent file in Journal format using TUI command.

April 26, 2017, 02:08	Writing iso-surface file	#23
aeroramji@gmail.com New Member Ramnath Join Date: Nov 2016 Posts: 10 Rep Power: 9	Hi everybody, I am simulating heat transfer problem in a rectangular duct for which I need to create more than 200 iso-surfaces. When I change the Reynolds number and run the simulation, I am supposed to create the same 200 iso-surfaces. Is there any way to use a set iso-surfaces created in one fluent to another fluent file in Journal format using TUI command.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

April 19, 2016, 14:26		#21
Supersonic New Member Join Date: Feb 2016 Posts: 9 Rep Power: 10	I did, but that only works for that specific case. I was hoping I could do it for one case, save it, and then copy and modify the case in Design Modeler. Thanks for the advice.

April 19, 2016, 15:02		#22
Supersonic New Member Join Date: Feb 2016 Posts: 9 Rep Power: 10	Hi Chris, Thank you for this post, it was very helpful! I have used this to create my 100 surface points. Now I have 3 quick questions. 1. When I do this it says "Warning : point creation failed" but when I "manage" my points, I can see them all there. Do you know why it is doing this? 2. Is there a way to check to make sure they are all in the correct place? 3. Is there a way to automatically (with code like before) group my points together into different groups? Thank you very much for the help!