A question about UDS (user difined scalar)

chaozhong.qin · September 19, 2010, 09:36

Hi, everyone

Thanks in advance.
Now I have a urgent problem on uds, which is as follows:

I want to know how to access the uds gradient on the boundary faces,
The manual shows C_UDSI_G(c,t,i) is used to obtain the cell gradient,so how about the face gradient? If no macro is available, is there another way to solve it?

MASOUD · September 21, 2010, 23:59

You may use F_UDSI_G insted.

chaozhong.qin · September 22, 2010, 06:21

Thanks,

The point is that I cannot find this macro: F_UDSI_G(f,t,i) in FLUNET manual.

Does it exist?

and how did you find this macro?

Thanks.

September 19, 2010, 09:36	A question about UDS (user difined scalar)	#1
chaozhong.qin New Member Steven Qhin Join Date: Jul 2010 Posts: 15 Rep Power: 17	Hi, everyone Thanks in advance. Now I have a urgent problem on uds, which is as follows: I want to know how to access the uds gradient on the boundary faces, The manual shows C_UDSI_G(c,t,i) is used to obtain the cell gradient,so how about the face gradient? If no macro is available, is there another way to solve it?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dieselFoam problem!! trying to introduce a new heat transfer model	vivek070176	OpenFOAM Programming & Development	10	December 24, 2014 00:48
User defined scalar	Tomik	FLUENT	0	February 8, 2007 20:23
Commercial software question (user viscosity)	Jeff	Main CFD Forum	2	July 20, 2002 11:41
Using user scalar in USRRAT	Jakub	CFX	0	April 25, 2002 14:18
User Scalar B/C	Greg Perkins	FLUENT	5	April 5, 2001 23:29

September 21, 2010, 23:59		#2
MASOUD Senior Member MASOUD Join Date: Mar 2009 Posts: 102 Rep Power: 18	You may use F_UDSI_G insted.

September 22, 2010, 06:21		#3
chaozhong.qin New Member Steven Qhin Join Date: Jul 2010 Posts: 15 Rep Power: 17	Thanks, The point is that I cannot find this macro: F_UDSI_G(f,t,i) in FLUNET manual. Does it exist? and how did you find this macro? Thanks.