|
[Sponsors] |
November 24, 2010, 01:18 |
Default calculation location??
|
#1 |
Member
Sandeep
Join Date: Jul 2010
Posts: 48
Rep Power: 15 |
Hello all,
I have a very basic question which is as below.... By default at which location the caluculations are done for temperature, pressure, velocity etc parameters....... is that at cell center or at the node points?? Please somebody answer me... Thanks sandeep |
|
November 24, 2010, 01:53 |
|
#2 |
Member
Join Date: Oct 2010
Posts: 45
Rep Power: 15 |
i think it depends on the kind of numerical scheme you employ for solution of equations. You may refer to some text book on numerical cfd (eg. Patankar) as a starting point
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 21:25 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |