|
[Sponsors] |
March 23, 2011, 10:53 |
Patching Volume Fraction in a sloped channel
|
#1 |
New Member
Katey
Join Date: Feb 2011
Location: Bozeman, MT
Posts: 7
Rep Power: 15 |
Hello. I'm running an open channel VOF model of a sloped channel and would like to be able to patch a volume fraction of 1 for the area under the water surface. I understand how to do this in a flat channel using region adaption in Fluent. I can't however figure out how to do this for a sloped channel in which the water surface is also sloped at approximately the same angle as the channel bottom.
any suggestions? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
interDyMFoam - change in volume fraction | gopala | OpenFOAM Running, Solving & CFD | 0 | April 27, 2009 10:46 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |