 |
 |
 |
|
|
|
[Sponsors] | ||||
September 25, 2011, 11:02
|
Droplet simulation (Boundary condition)
|
#1 |
|
New Member
Edward Listijono
Join Date: Aug 2011
Posts: 2
Rep Power: 0  |
Hi everyone! I am trying to simulate a water droplet and I am having trouble with error messages like:
" Error: floating point exception Divergence detected in AMG solver: x-momentum Divergence detected in AMG solver: y-momentum Divergence detected in AMG solver: temperature Divergence detected in AMG solver: pressure correction Primitive error at Node 0: floating point error " Its a rectangular 2-D model with left side set as axisymmetric (simulating just half a droplet) top and right side as inlet and bottom side as wall. I'm using VOF as model and solution method as PISO. Any help will be greatly appreciated. Thanks. |
|
|
|
|
 |
| Tags |
| boundary condition, droplet simulation, floating point error, vof |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting outlet Pressure boundary condition using CAFFA code | Mukund Pondkule | Main CFD Forum | 0 | March 16, 2011 04:23 |
| Boundary Condition question for Cooling Water Pumps Bay Simulation | Jaimito | FLUENT | 0 | August 3, 2010 07:58 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
| Boundary Condition for single droplet evaporation | Deepak Kumar Mandal | Siemens | 0 | January 30, 2007 10:25 |
| Boundary condition, UDF, Wave simulation | hm | FLUENT | 0 | August 2, 2004 22:45 |
Linear Mode
