|
[Sponsors] |
June 10, 2012, 18:02 |
Acceptable mesh quality???
|
#1 |
Senior Member
Danial
Join Date: Nov 2011
Posts: 179
Rep Power: 14 |
Hi ,
This is my mesh details and i am worried about Exp factor value as document states that it (Range) should be less than 20. I am using Hexdominant mesh for homogeneous multiphase problem including free surface and thermal energy model. Could any one please tell me if it is acceptable or total failure?? it will save me a lot of time. Thanks +--------------------------------------------------------------------+ | Mesh Statistics | +--------------------------------------------------------------------+ | Domain Name | Orthog. Angle | Exp. Factor | Aspect Ratio | +----------------------+---------------+--------------+--------------+ | | Minimum [deg] | Maximum | Maximum | +----------------------+---------------+--------------+--------------+ | D1 | 9.2 ! | 208 ! | 74 OK | | D2 | 5.6 ! | 399 ! | 98 OK | | Global | 5.6 ! | 399 ! | 98 OK | +----------------------+---------------+--------------+--------------+ | | %! %ok %OK | %! %ok %OK | %! %ok %OK | +----------------------+---------------+--------------+--------------+ |D1 | <1 <1 100 | <1 1 99 | 0 0 100 | | D2 | <1 1 99 | <1 1 99 | 0 0 100 | | Global | <1 <1 100 | <1 1 99 | 0 0 100 | +----------------------+---------------+--------------+--------------+ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Polyhedral Mesh Quality in Star-CCM+ | niazaliahmed | STAR-CCM+ | 3 | March 8, 2012 13:51 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |