CFD Online Logo CFD Online URL
Home > Forums > Main CFD Forum

Mass Flow rate in spray water modeling

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   June 8, 2013, 15:48
Default Mass Flow rate in spray water modeling
New Member
Join Date: Sep 2011
Location: Iran
Posts: 20
Rep Power: 8
Behnam Ghadimi is on a distinguished road
I am running a spray simulation using FLUENT in which a cold water injects through a hot air stream.the geometry is a rectangular channel and there is an injection in the middle of the channel.
I did the modeling using following conditions:

1) Air mass flow rate (main flow) =1.165 kg/s
2) injected water mass flow rate =0.5 kg/s
3) water injection was modeled using particle injection modeling.
3)Exit is pressure outlet.

In the post processing, it shows after very well convergence,

Mass inlet = 1.165 kg/s
Mass outlet= -1.165 kg/s

It seems that the Injected water mass is not added to the main flow.
Should I have to change or use some other models?

If anybody have any useful advice I will appreciate.
Thank you in advance
Behnam Ghadimi is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
UDF to measure Mass Flow Rate a.lynchy Fluent UDF and Scheme Programming 22 September 26, 2017 12:50
Mass flow rate: calculation v/s computation beguxa FLUENT 4 June 8, 2013 16:17
2D axisymmetric mass flow rate for the plain orifice atomizer jwillie2000 FLUENT 2 September 17, 2010 05:43
Determine mass flow rate along flow path Atit Koonsrisuk CFX 2 October 5, 2003 04:47
mass flow inlet Denis Tschumperle FLUENT 7 August 9, 2000 02:19

All times are GMT -4. The time now is 01:39.