|
[Sponsors] |
July 19, 2007, 12:48 |
Gambit meshing problem
|
#1 |
Guest
Posts: n/a
|
Hi everyone
I have plotted points in the 3D domain in Gambit and connected those with the same depth to create lines representing the bathymetric geometry. I have then created a box around this to allow me to apply an velocity input to see what happens to the sea flow as it passes over there varying depths. Ok. I have meshed all the connecting lines and then tried to mesh the volume, when I encountered a problem. It is telling me; "face 13 could not be converted to a submappable region" Could someone tell me what might make a face "un-submappable"? What are the best settings for meshing a volume like this? Thankyou all |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GAMBIT meshing problem for boundary layer | Falah | FLUENT | 2 | November 30, 2020 15:16 |
Problem with Ansys meshing | Asghari_M | ANSYS Meshing & Geometry | 1 | June 8, 2011 11:38 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 06:22 |
Problem starting Gambit | ViHAR MALViYA | FLUENT | 0 | November 10, 2006 11:26 |
Gambit Meshing Problem | Drew | FLUENT | 3 | April 1, 2005 11:50 |