Boundary Layer Thickness Variation

mazhar16823 · July 23, 2020, 07:21

Hi Everyone,

I have noticed that the BL Thickness (boundary layer edge) post-simulation is less than what I provided to the prism layer mesher. In this case, do I need to reduce the number of prism layers and increase the growth rate? or I have to keep the same number of prism layers and reduce the growth rate to encapsulate the whole boundary layer?

Thanks for your time.

Best regards,

aero_head · December 1, 2020, 17:47

Hello Mazhar,

If you are using ICEM CFD, it is better to generate one prism layer of the total thickness of the boundary layer. So I would choose the section option.

You can then use Edit Mesh > Split Mesh >Split Prisms to divide this layer into the required number of layers. To ensure the first layer is equal to the thickness that gives you y+ = 1, you can use Fixed initial height option.

I noticed this is from awhile back, what did you do in the end?

July 23, 2020, 07:21	Boundary Layer Thickness Variation	#1
mazhar16823 Senior Member MA Join Date: Mar 2020 Posts: 163 Rep Power: 6	Hi Everyone, I have noticed that the BL Thickness (boundary layer edge) post-simulation is less than what I provided to the prism layer mesher. In this case, do I need to reduce the number of prism layers and increase the growth rate? or I have to keep the same number of prism layers and reduce the growth rate to encapsulate the whole boundary layer? Thanks for your time. Best regards,

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Out File does not show Imbalance in %	Mmaragann	CFX	5	January 20, 2017 10:20
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 05:15
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 06:20
Questions about Boundary Layer Thickness and Turbulence Models	famerfamer	STAR-CCM+	3	July 12, 2012 09:47
boundary layer thickness	98.4F	Main CFD Forum	1	December 29, 2000 07:23

December 1, 2020, 17:47		#2
aero_head Senior Member Kira Join Date: Nov 2020 Location: Canada Posts: 435 Rep Power: 8	Hello Mazhar, If you are using ICEM CFD, it is better to generate one prism layer of the total thickness of the boundary layer. So I would choose the section option. You can then use Edit Mesh > Split Mesh >Split Prisms to divide this layer into the required number of layers. To ensure the first layer is equal to the thickness that gives you y+ = 1, you can use Fixed initial height option. I noticed this is from awhile back, what did you do in the end?