|
[Sponsors] |
April 29, 2008, 14:03 |
Surface Repair for Meshing
|
#1 |
Guest
Posts: n/a
|
Folks, We normally run classes of problems with tractable bottom up geometry which we mesh in a straightforward fashion using Gridgen, ICEM or Gambit as appropriate.
We are now running into problems where we get cad geometry which is simply not going to work out of the box. These are underhood, external aero type problems but they are not automotive. Cant say more. As an ex-adapco Prostar user, I would have used ProAm or whatever its called now and wrapped the surface to get a contiguous surface for meshing. Whats the state of third party tools that perform these sort of functions? I see that ANSA is still a playere here. Any other tools that can do this? Any that are cheap or free ;-) Thanks - Andy |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |