|
[Sponsors] |
April 30, 2016, 11:59 |
Edge not aligning properly
|
#1 |
New Member
vijaykamesh
Join Date: Dec 2015
Posts: 12
Rep Power: 10 |
Hello,
I'm facing a minor problem in edge alignment. The vertices are connected and it supposed to be straight but when i give projected mesh option. I can see some bend in the edge where connecting to the vertices. Please see pics. I tried edit edges option and checked vertices positions both are in same height only. The bad elements are occuring due to this problem. In other side of the geometry, there is no bending edges like this. Please help me to fix this issue. two vertices.jpg edge_bend.jpg edge_bend1.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Shifted Periodic topology | venkat_aero2007 | ANSYS Meshing & Geometry | 17 | August 27, 2013 01:41 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |