outlet boundary condition of numerical wave tank

gyouth · August 25, 2016, 08:39

hello,every CFDer! I'm working at simulating a numerical wave tank with the commercial solver STAR-CCM+. There are somethings puzzled me, I hope you can give me some suggestions. My question is :
How should I define the outlet pressure condition of numerical wave tank?
I have tried two different BCs at the outlet.First, I prescribed the pressure at the outlet with hydrostatic pressure of undisturbed water surface(flat wave in STAR-CCM+), but I find the water level at the outlet will decrease gradually. Then, I tried another boundary condition, and I set zero gradient of pressure at the outlet with STAR-CCM+'s user defined field function (scalar->pressure->ignore boundary values) , but I find the water level at the outlet will increase gradually. Now I'm very puzzled. I hope somebody can help me to deal with this matter.

Marpole · August 25, 2016, 11:18

you may need run a longer time to reach the equilibrium state. If the outlet has higher hydraulic pressure as in you first case, the inflow is more than the outflow, the water surface rises such that inflow decreases and outflow increases. At one point, they reach equilibrium. In the other case, when you set zero gradient, the outflow is more than the inflow. Thus the surface decreasing so that inflow increases and the outflow decreases.

August 25, 2016, 08:39	outlet boundary condition of numerical wave tank	#1
gyouth New Member gyh Join Date: Dec 2015 Posts: 2 Rep Power: 0	hello,every CFDer! I'm working at simulating a numerical wave tank with the commercial solver STAR-CCM+. There are somethings puzzled me, I hope you can give me some suggestions. My question is : How should I define the outlet pressure condition of numerical wave tank? I have tried two different BCs at the outlet.First, I prescribed the pressure at the outlet with hydrostatic pressure of undisturbed water surface(flat wave in STAR-CCM+), but I find the water level at the outlet will decrease gradually. Then, I tried another boundary condition, and I set zero gradient of pressure at the outlet with STAR-CCM+'s user defined field function (scalar->pressure->ignore boundary values) , but I find the water level at the outlet will increase gradually. Now I'm very puzzled. I hope somebody can help me to deal with this matter.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Outlet boundary condition for wave flume with interFoam solver	Arnoldinho	OpenFOAM	9	July 10, 2018 05:15
UDF fluent:Change boundary condition. determination inlet and outlet boundary in "t"	gzamiri@gmail.com	FLUENT	0	September 27, 2015 05:32
What outlet BC to use for a numerical wave tank with a velocity inlet?	JamesJ	FLUENT	1	August 8, 2012 17:43
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
VOF Outlet boundary condition in cfd - ace	JM	Main CFD Forum	0	December 15, 2006 08:07

August 25, 2016, 11:18		#2
Marpole Senior Member Charles Join Date: Aug 2016 Location: Vancouver, Canada Posts: 148 Rep Power: 9	you may need run a longer time to reach the equilibrium state. If the outlet has higher hydraulic pressure as in you first case, the inflow is more than the outflow, the water surface rises such that inflow decreases and outflow increases. At one point, they reach equilibrium. In the other case, when you set zero gradient, the outflow is more than the inflow. Thus the surface decreasing so that inflow increases and the outflow decreases.