COMSOL rotating machinery problem

30na · August 23, 2015, 10:07

Hi there, I am quite new to COMSOL. I am trying to simulate a rotating container (with rotating machinery) which is filled with a fluid and has no flow inlet or outlet. I also wish to release some particles (with particle tracing module) in this container and track their paths, so there is a particle inlet and outlet but none for the flow.
Can this be done? I encountered an error while trying to do this?
Any help will be greatly appreciated.

cfd_amigo · November 8, 2016, 10:01

Hi. Yes it can be done, just make sure to do a correct setup of all domains and boundary conditions. Good luck.

August 23, 2015, 10:07	COMSOL rotating machinery problem	#1
30na New Member Join Date: Jan 2014 Posts: 26 Rep Power: 12	Hi there, I am quite new to COMSOL. I am trying to simulate a rotating container (with rotating machinery) which is filled with a fluid and has no flow inlet or outlet. I also wish to release some particles (with particle tracing module) in this container and track their paths, so there is a particle inlet and outlet but none for the flow. Can this be done? I encountered an error while trying to do this? Any help will be greatly appreciated.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rotating wall velocity boundary condition for axisymmetric flow problem	diwakaranant	SU2	1	March 23, 2013 23:45
Simulating rotating machinery in oposite directions	j.abernathie	STAR-CCM+	6	August 12, 2012 22:42
Problem with the 2D rotating blade-CFX-12.1	Araz	CFX	5	September 3, 2011 07:54
comsol cantilever beam problem	bhu47	COMSOL	0	June 30, 2008 14:59
rotating bucket problem	brown	CFX	2	October 3, 2007 01:13

November 8, 2016, 10:01		#2
cfd_amigo New Member Allan Join Date: Oct 2016 Posts: 2 Rep Power: 0	Hi. Yes it can be done, just make sure to do a correct setup of all domains and boundary conditions. Good luck.