 |
 |
 |
|
|
|
[Sponsors] | ||||
February 27, 2018, 06:12
|
inflation layer
|
#1 |
|
New Member
A SWAMY NAIDU
Join Date: Feb 2018
Posts: 2
Rep Power: 0  |
hello everyone
how to give inflation layer inside ogrid for a low Re airfoil in ICEM CFD . what is this error mean WARNING: Mesh has uncovered edges. ANSYS Fluent needs a complete boundary (lines in 2D) or it will give a variety of errors and not read in the mesh! If this was 2D Hexa, perhaps your edges are not associated with perimeter curves Thank You |
|
|
|
|
 |
| Tags |
| inflation layer, ogrid |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Help with Snappy: no layers growing | GianF | OpenFOAM Meshing & Mesh Conversion | 2 | September 23, 2020 08:26 |
| [ANSYS Meshing] 2D inflation layer contains triangles | jones007 | ANSYS Meshing & Geometry | 8 | May 4, 2020 08:42 |
| Boundary Layer - Inflation Layer | dlkadk | FLUENT | 0 | September 16, 2017 11:11 |
| Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |
Linear Mode
