|
[Sponsors] |
March 16, 2020, 15:17 |
Why does the checkMesh fail after using arc
|
#1 |
New Member
Masih
Join Date: Feb 2020
Posts: 22
Rep Power: 6 |
Hi all,
I am trying to convert a cubic to cylinder. Before starting using arc in the edges, everything was fine. Then, I tried to curve a side. After implementing blockMesh, I have not got any error but after command "checkMesh", I got an error saying that "failed 1 mesh checks". I checked paraview and everything was exactly what I expected. I also ran a simulation and it seemed that it worked properly. So, I wonder why I got this error and how I can deal with that? I just found something new which may help. I switched to 2D and the problem was gone. So what can I do to solve this problem in 3D? Best regards, Masih |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Openfoam: Meshing, where do my defaultFaces come from | syntex | OpenFOAM Meshing & Mesh Conversion | 19 | December 10, 2018 07:21 |
settlingFoam unstable? | bendel_boy | OpenFOAM Running, Solving & CFD | 38 | July 8, 2016 05:07 |
[blockMesh] Another cylinder question | bendel_boy | OpenFOAM Meshing & Mesh Conversion | 5 | January 6, 2015 05:09 |
[Other] mergeMatchPairs with arcs | vainilreb | OpenFOAM Meshing & Mesh Conversion | 1 | August 5, 2013 08:11 |
[blockMesh] apparently the mesh doesn't want to be created in one direction | Maxime Thomas | OpenFOAM Meshing & Mesh Conversion | 1 | August 18, 2012 06:05 |