|
[Sponsors] |
May 17, 2020, 00:44 |
Negative pressure room
|
#1 |
New Member
Seran Reschim
Join Date: Jun 2012
Posts: 9
Rep Power: 13 |
I am working on the negative pressure simulation by CFX. I set the inlet 450 CFM and set the outlet at 600 CFM. Unfortunately, the room pressure show positive pressure. I dont know how to make it go to negativee pressre. However, my friend use solidwork simulation on this situation. It shows negative pressure. I would like to know how CFX can do the negative pressure. Thx
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
static vs. total pressure | auf dem feld | FLUENT | 17 | February 26, 2016 13:04 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
negative pressure | mAx | FLUENT | 0 | January 25, 2006 14:31 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |