|
[Sponsors] |
September 29, 2021, 11:12 |
oparallel in Xflow software, number of cpus
|
#1 |
New Member
Dung Feng
Join Date: Jul 2012
Posts: 1
Rep Power: 0 |
I'm using Xflow 2020x software.
Yesterday’s calculation of more than 400,000 grid CPUs used 90%, but today’s calculation of 570,000 grid CPUs only used about 30% I want to know how It can use more CPU during analysis and so reduce the calculation time? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 09:12 |
Decomposing error simple method | DanGode | OpenFOAM Pre-Processing | 1 | July 27, 2021 06:58 |
Foam-Extend 4.0 simpleFoam motorbike parallel error? | EternalSeekerX | OpenFOAM Running, Solving & CFD | 0 | May 10, 2021 04:55 |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
[blockMesh] --> foam fatal error: | lillo763 | OpenFOAM Meshing & Mesh Conversion | 0 | March 5, 2014 10:27 |