|
[Sponsors] |
December 24, 2021, 02:03 |
Creo: fix tangential pitch
|
#1 |
New Member
haider ali
Join Date: Jul 2011
Posts: 8
Rep Power: 14 |
Hello,
I am drawing holes on a shaft and want to fix the tangential pitch to 9 mm. I have attached the images. Could anyone let me know how to fix the tangential pitch between holes? I am getting only the option in degrees when I use CAD softwares (creo, autocad etc.). Can anyone help me on that? Regards Haider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Correct 'pitch' value to use in MISES | JoeRob28 | Main CFD Forum | 1 | May 6, 2019 11:55 |
ActuatorDiskExplicitForce in OF2.1. Help | be_inspired | OpenFOAM Programming & Development | 10 | September 14, 2018 11:12 |
[Workbench] Issue Configuring Creo 2.0 with Ansys Associative Interface | Conor Ryan1 | ANSYS Meshing & Geometry | 0 | February 1, 2015 10:56 |
Problem with time average tangential velocity in swirl flow. | lakhi | FLUENT | 5 | July 18, 2012 16:28 |
Mesh Motion pitch on a hull | Seb | CFX | 1 | February 23, 2009 13:04 |