Simulation not Converging in STAR-CCM+ -- CFD Online Discussion Forums

June 6, 2022, 17:57

Simulation not Converging in STAR-CCM+

faceres97

New Member

Francisco

Join Date: May 2022

Posts: 4

Rep Power: 5

Hello all

I am trying to run a simulation on a T106C Turbine blade but my simulation is not converging. I suspect there is a problem with my boundary conditions. I am trying to impose periodic boundary conditions on the top, bottom, and two span-wise boundaries as seen in the attached figures.

I created interfaces but I am not sure what type of interface to assign. I assigned Fully-Developed Interface with Periodic Topology and Translational Periodicity.

Anyone knows if I am doing anything wrong here?

FC

Attached Images

	Fig. 1.PNG (9.0 KB, 13 views)
	Fig. 2.PNG (13.3 KB, 10 views)

Tags

boundary conditions, interfaces, star-ccm+

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Import Table Data For a New Simulation in STAR CCM+	Raamses	STAR-CCM+	3	March 18, 2021 21:15
problem when imported geometry from 3D CAD to star ccm,	TAREK GANAT	STAR-CCM+	1	May 21, 2013 23:15
Thermal Comfort Simulation in STAR CCM+	anupmu	STAR-CCM+	1	February 27, 2013 15:25
Problem In Star CCM Plus	ramarya	STAR-CCM+	1	July 10, 2011 06:59
CFD-analysis of hydroplane: STAR CCM or Flow Simulation?	peterg07	Main CFD Forum	0	February 7, 2010 15:32

All times are GMT -4. The time now is 08:37.