|
[Sponsors] |
|
June 22, 2023, 07:27 |
Set Correct Boundary Condition
|
#1 |
New Member
Agung
Join Date: Jun 2023
Posts: 4
Rep Power: 3 |
Hi I have a simulation issue with fluent
I have this scenario where the air comes from the tunnel (black arrow), all the way to the middle tunnel (Junction) where it will suct by the duct (green arrow) to transport to the back of the tunnel (tosca arrow) and all the air inside the tunnel wit suct by duct from the middle tunnel to the surface (Blue arrow). I have tried to simulate it and it always gives a floating point exception and i suggest it came from the wrong boundary conditions. And also the tosca arrow which should be out from duct but the vector arrow is pointing inside the tunnel (fluent recognized the duct is outside the domain) what should I do? anny suggestion what should boundary condition of each arrow is ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about different kinds of Boundaries and Boundary Conditions | granzer | Main CFD Forum | 17 | April 12, 2022 17:27 |
Using gnuplot to plot probe data | Rotidpor | OpenFOAM | 3 | March 9, 2022 05:44 |
How to set Open boundary condition in FLUENT? | vincenzolights | FLUENT | 5 | March 30, 2020 10:40 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |