Heat Flux not being reported provided wall temperature (STAR-CCM)

kev11 · April 21, 2024, 17:22

Hello experts,

I am using STAR-CCM to analyze a few aerothermal properties on a hypersonic vehicle. I settled up a report to output the Surface Average of Boundary Heat Flux on Latest Surface," but I am getting a "no data, undefined ratio" error.

However, when plotting the scalar field of the boundary heat flux, I can clearly see some results. Please see the screenshot attached to this message for more details (yes, this hypersonic vehicle is unrealistic-looking, but ignore that for now, lol).

Why am I getting this error? I set the wall BC condition to a constant wall temp at 300 K if that helps understand the problem at hand.

Please help I am super confused.

Best,

Kev11

LuckyTran · April 21, 2024, 17:26

You want the latest mesh, not the latest surface. Similarly, make sure you select the surfaces in regions and not parts.

CAD is CAD. CAD is not CFD.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How Ansys Flunet Calculte the Wall Heat Flux?	eddie4160	FLUENT	0	October 24, 2023 23:21
Averaging over iterations for steady-state simulation	CFD student	Fluent UDF and Scheme Programming	8	September 22, 2022 04:39
Heat flux as a function of wall temperature using UDF	Piquero	FLUENT	2	May 7, 2021 13:02
Temperature dependent wall heat flux	justinc	FLUENT	3	January 25, 2020 04:36
Natural convection in a closed domain STILL NEEDING help!	Yr0gErG	FLUENT	4	December 2, 2019 01:04

April 21, 2024, 17:26		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,777 Rep Power: 66	You want the latest mesh, not the latest surface. Similarly, make sure you select the surfaces in regions and not parts. CAD is CAD. CAD is not CFD.