|
[Sponsors] |
June 7, 2001, 16:44 |
Acceptable Accuracy or Error?
|
#1 |
Guest
Posts: n/a
|
If one were to model a turbomachine in order to calculate the pressure ratio, what would the common acceptable error in a 3D multiple frame of reference anaylsis? I realize this figure will vary from industry to industry; however, I am curious as to what most users of commercial codes deem as a 'worthy' solution.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 17:43 |
compile errors of boundary condition "expDirectionMixed" | liying02ts | OpenFOAM Bugs | 2 | February 1, 2010 20:11 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |
Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |