Surface in Star-CD

February 3, 1999, 18:26

Hello! Does anybody know how to generate a 3D surface in Star-CD? I want to have control on internal points also, not just points on edges.

And could somebody tell me if it is possible to use "block" technique to mesh a flow passage bounded by six 3D surfaces?

Thanks a lot for your time.

Shijin

Email: shuang@iastate.edu

February 4, 1999, 14:45

Please read the manual.

You should have a look at the commands spline , patch vproject and vsmoo and maybe some others.

There is also something about block meshing in the tutorial additionally with the easy-giu starting from page 548.

February 3, 1999, 18:26	Surface in Star-CD	#1
Shijin Huang Guest Posts: n/a	Hello! Does anybody know how to generate a 3D surface in Star-CD? I want to have control on internal points also, not just points on edges. And could somebody tell me if it is possible to use "block" technique to mesh a flow passage bounded by six 3D surfaces? Thanks a lot for your time. Shijin Email: shuang@iastate.edu

February 4, 1999, 14:45	Re: Surface in Star-CD	#2
Joern Beilke Guest Posts: n/a	Please read the manual. You should have a look at the commands spline , patch vproject and vsmoo and maybe some others. There is also something about block meshing in the tutorial additionally with the easy-giu starting from page 548.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
continuum surface tension model	yukn	Main CFD Forum	0	October 8, 2011 06:43
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 06:47