|
[Sponsors] |
July 26, 2011, 07:38 |
Boundary Conditions
|
#1 |
New Member
blaze
Join Date: Mar 2009
Posts: 11
Rep Power: 17 |
I have confusion on the BC's to be used for the below cases when I have fluid flowing through the pipe.
1. when the gas is superheat at 80C. 2.when it is two phase at 60C and 3. when it is subcooled at 50C. Im using Fluent, what kind of BC do I use. I believe using wall temps with the above gas temp will be incorrect. Appreciate your help. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
OpenFOAM Variable Velocity Boundary Conditions | NickolasPl | OpenFOAM Programming & Development | 2 | May 19, 2011 05:37 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |