|
[Sponsors] |
3D-Simulation of Steam generator (Sodium-water/steam heat exchanger) |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Nandakumar
Join Date: Dec 2009
Location: India, Kalpakkam
Posts: 1
Rep Power: 0 ![]() |
This is Nandakumar,
Could any one suggest methodology and software for simulation of Once through counter flow steam generator heated by hot liquid sodium at low pressure on shell side, heating sub-cooled water into super heated high pressure steam on vertical tubes. Two phase flow is also encountered in this water side flow. Earlier we have used 1D code for both sodium and water side, with heat transfer and pressure drop correlations for different boiling zones. Now we would like to simulate in 3D to find the temperature and flow mal-distribution radially, circumferential and axially. The SG is having 30m long 475 tubes each 12mm ID in 30mm triangular pitch. Regards, Nandakumar |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat exchanger design | sakthi | Main CFD Forum | 6 | September 3, 2022 02:22 |
heat exchanger in typical air-conditioning system! | Yang Bin | Main CFD Forum | 0 | May 11, 2005 09:16 |
BIG TROUBLE with heat exchanger and porous media!! | Andrea | FLUENT | 0 | February 20, 2005 08:49 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
calculation of shell-and-tube heat exchanger | alex | Phoenics | 4 | August 28, 2001 04:06 |