|
[Sponsors] |
Simulation of condensation/evaporation using VOF model in Fluent4.5 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 27, 1999, 12:48 |
Simulation of condensation/evaporation using VOF model in Fluent4.5
|
#1 |
Guest
Posts: n/a
|
Did anyone tried to use Fluent 4.5 to simulate condensation/evaporation problem? It is stated in the manual that source term in both VOF equation and pressure correction equation are needed. The source term in VOF equation is straightforward. However, I do not understand why there should be a source term in pressure correction equation. The fluid just changed from one phase to another, the total mass is not changed in the process. Please post your experience!
Thank you very much!!! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wich model in gas-gas (VOF, MM or EM) | louiza | FLUENT | 0 | May 25, 2010 06:59 |
Doubts UDS Flux, UDS Unsteady for VOF model | kel85uk | FLUENT | 0 | March 17, 2010 09:53 |
VOF Model or Mixture Model | mems21 | FLUENT | 2 | March 9, 2010 11:37 |
multiphase flow VOF model set up | rahaman | FLUENT | 0 | June 9, 2009 04:49 |
VOF model | heri | FLUENT | 6 | April 22, 2008 12:02 |