|
[Sponsors] |
simulation of piston motion inside a hydraulic cylinder |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 7, 2011, 02:40 |
simulation of piston motion inside a hydraulic cylinder
|
#1 |
New Member
mohd
Join Date: May 2011
Posts: 3
Rep Power: 15 |
I am a student working on Fluent to simulate motion of a piston inside a cylinder.
The cylinder has two ports, one on the left and the other on the right end. The piston can take any initial position inside the cylinder. There will be three zones: solid zone (the piston) at the center ; two fluid zones, one at each side of the piston. When pressurized oil inter the cylinder from one side (say left port) the piston will be forced by the oil pressure to move to the other side (right). The piston in turn forces the oil on its right side to flow out the cylinder through the right port. I need C code from similar example to guide me. or if any one of you can help me by any sort of guidelines. My email address: m.osman6m@gmail.com
__________________
M.osman Last edited by mosman; August 8, 2011 at 03:23. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappHexMesh Mesh creating a Mesh inside a Cylinder? | abu | OpenFOAM Meshing & Mesh Conversion | 1 | April 4, 2017 10:57 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
[snappyHexMesh] SnappyHexMesh Meshing inside a cylinder | nammari | OpenFOAM Meshing & Mesh Conversion | 5 | March 11, 2011 20:49 |
how to mesh cylinder inside the square duct | kathir | Siemens | 1 | August 1, 2006 09:44 |
Hydraulic pump -3d simulation paper | ken elms | Main CFD Forum | 2 | April 2, 2001 05:19 |