|
[Sponsors] |
May 26, 2005, 14:12 |
How to treat BC at center of O mesh???
|
#1 |
Guest
Posts: n/a
|
Use an O mesh (polar system) to calculate an incompressible flow. How to set BC at the center of the O mesh, to where all mesh lines in the radius direction sink?
How about interpolation, or, average? Thanks for comments and sharing your experinece. DISC |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |