|
[Sponsors] |
October 11, 2005, 00:40 |
KIVA Simulation
|
#1 |
Guest
Posts: n/a
|
Dear All:
I am trying to simulate a 4-stroke engine motion with KIVA 3V R2. Fuel injections are supposed to be at 330 CAD and 372 CAD. While all fuel evaporated, there is no combustion through the cycle. Could anyone provide some advice on the issue? Thanks in advance. Felix |
|
October 12, 2005, 07:18 |
Re: KIVA Simulation
|
#2 |
Guest
Posts: n/a
|
If you use ca1inj to specify the start of injection t1inj has to be set to -1.0. If the injected fuell mass (tspmas) is too low, you do not notice combustion. Temperature has to be high enough. I know that it's all obvious, but happend to me.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GUI crash and simulation engine still running | RPJones | FLOW-3D | 2 | November 9, 2010 08:18 |
velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 18:57 |
Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |
correction of KIVA Itape | hama | Main CFD Forum | 0 | May 2, 2006 03:41 |
Restarting KIVA simulation | Tomislav | Main CFD Forum | 2 | April 5, 2006 03:22 |