|
[Sponsors] |
August 5, 2015, 07:53 |
makeAxialMesh error.
|
#1 |
Member
Marco Bernardes
Join Date: May 2009
Posts: 57
Rep Power: 17 |
Hi,
I'm trying to create a axissymetric mesh using the makeAxialMesh command. I'm getting the following message: ================================================== ===== --> FOAM FATAL ERROR: Symmetry plane 'center' is not planar. At local face at (0 996.212 25) the normal (0 0 0) differs from the average normal (-0.20202 0 0) by 0.0408122 Either split the patch into planar parts or use the symmetry patch type From function symmetryPlanePolyPatch::n() in file meshes/polyMesh/polyPatches/constraint/symmetryPlane/symmetryPlanePolyPatch.C at line 64. FOAM exiting ================================================== ====== The fact remains that a surface which is clearly planar (defined by points with same z-values) is classified as non-planar. I have changed the patch type to symmetry but the problem persists. Any help is appreciated. Thanks, Marco. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |