|
[Sponsors] |
How to repair the missing patches of the mesh on a wing? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 17, 2016, 06:23 |
How to repair the missing patches of the mesh on a wing?
|
#1 |
New Member
Kewan
Join Date: May 2016
Posts: 1
Rep Power: 0 |
hi everyone
I'm working on a project in which I have to do the CFD analysis of an elevator of a jet trainer aircraft. And I'm having problem with the mesh generation. Even after completing each step carefully so many times the mesh ends up with the small missing patches on the wing near trailing edge. That is definitely going to affect the results. so it will be highly appreciated if someone could guide me through it. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[ICEM] Missing face error from FLUENT even after repairing mesh + other questions | unknown159 | ANSYS Meshing & Geometry | 0 | July 5, 2013 20:18 |
errors when installing openfoam2.1 on ubuntu12.o4 | hewei | OpenFOAM Installation | 5 | May 29, 2012 07:43 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |