problem with translation

johncarouche · July 2, 2009, 04:52

Hi!
I have a file X_T( parasolid) to define my blade. The trouble is that it is located too close from r=0. As a consequence, the curve of the hub cuts r=0.
So, I have to make a translation.
I translate the hub, the shroud and the blade. When I try to link the blade which has been translated, it didn't match with the hub and the shroud in the meridional view.
I don' understand because I apply the same translation to the blade , the shroud and the hub.
any idea?

afeng0796 · July 21, 2009, 04:59

use the "bulb" Button，and use the bulb function

July 2, 2009, 04:52	problem with translation	#1
johncarouche New Member Join Date: Jun 2009 Posts: 2 Rep Power: 0	Hi! I have a file X_T( parasolid) to define my blade. The trouble is that it is located too close from r=0. As a consequence, the curve of the hub cuts r=0. So, I have to make a translation. I translate the hub, the shroud and the blade. When I try to link the blade which has been translated, it didn't match with the hub and the shroud in the meridional view. I don' understand because I apply the same translation to the blade , the shroud and the hub. any idea?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Incoherent problem table in hollow-fiber spinning	Gianni	FLUENT	0	April 5, 2008 10:33
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

July 21, 2009, 04:59		#2
afeng0796 New Member deng qingfeng Join Date: Jul 2009 Posts: 9 Rep Power: 16	use the "bulb" Button，and use the bulb function