 |
 |
 |
|
|
|
[Sponsors] | ||||
June 20, 2014, 12:45
|
porouswavefoam/gambit mesh
|
#1 |
|
New Member
Join Date: Apr 2014
Posts: 6
Rep Power: 12  |
Hii
Im try to simulate a porous breakwater with wave generation on waves2foam using porousWaveFoam with Gambi mesh. My problem is that when i run fluentMeshToFoam to convert the msh file the porosity zone is not defined at cellZones. So when i run the solver the porosity information is not found so i get error. Can you help me? Regards Diogo Afonso |
|
|
|
|
|
June 21, 2014, 05:57
|
|
#2 |
|
Senior Member
Niels Gjoel Jacobsen
Join Date: Mar 2009
Location: Copenhagen, Denmark
Posts: 1,900
Rep Power: 37 |
Good morning,
@DA14: This is a pre-processing/meshing question, so please refer it to an appropriate thread. Kind regards, Niels
__________________
Please note that I do not use the Friend-feature, so do not be offended, if I do not accept a request. Last edited by wyldckat; October 8, 2018 at 10:26. Reason: removed answer to another post that was on the main thread |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Linear Mode
