|
[Sponsors] |
June 25, 2018, 06:33 |
pimpleDyMFoam with groovybc
|
#1 |
New Member
wiki
Join Date: Apr 2017
Posts: 3
Rep Power: 9 |
Hi all,
Good day everyone, I am simulating flow past circular cylinder with periodic blowing and suction from the top and bottom surface of the cylinder. In order to implement blowing and suction, i am using groovybc for the cylinder wall with mathematical expression,i.e vel_n=sin(2pi*f*t)*Gaussionfunction*sin(2pi*z/Lz). where vel_n is normal to surface velocity and Lz is spanwise domain length. I want to simulate VIV with openfoam with this blowing and suction from the cylinder wall. I used pimpleDyMFoam for VIV with rigidbodysixdofsolver in openfoam. The sixdofsolver specifies the boundary type of movingwallvelocity for the cylinder surface and does not allow to provide groovybc additionally for the same wall. I want to give both boundary conditions,i.e. groovybc and movingwallvelocity to the same patch,i.e. cylinder surface. I would appreciate help for cfd community. regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] Change in alpha and U with groovyBC in twoPhaseEulerFoam | dani2702 | OpenFOAM Community Contributions | 0 | November 17, 2016 03:30 |
[swak4Foam] groovyBC issue - k and epsilon | sagnikmazumdar | OpenFOAM Community Contributions | 24 | March 1, 2015 07:16 |
Savonius pimpleDyMFoam | vitokad | OpenFOAM Pre-Processing | 10 | September 16, 2014 09:30 |
[swak4Foam] Running pimpleDyMFoam with groovyBC | lexmatt | OpenFOAM Community Contributions | 2 | August 16, 2013 15:08 |
[swak4Foam] groovyBC and Eqn.setReference() | benk | OpenFOAM Community Contributions | 3 | June 2, 2011 08:49 |