|
[Sponsors] |
January 21, 2016, 10:04 |
create plots remote without X11
|
#1 |
Senior Member
Gerhard Holzinger
Join Date: Feb 2012
Location: Austria
Posts: 342
Rep Power: 28 |
Is it possible to use pyFoamPlotWatcher to create plots (say, of the residuals) remotely on a cluster without X11 forwarding?
When I try, I get the following error messages. Code:
gnuplot: unable to open display '' gnuplot: X11 aborted. |
|
Tags |
plotting, pyfoam, remote |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 07:47 |
[ICEM] how to create a 2d tri mesh with quad mesh in the boundary layer | seal2013 | ANSYS Meshing & Geometry | 3 | October 6, 2013 17:09 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 08:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 02:07 |
drawing of contour plots | chinthakindi | Main CFD Forum | 1 | April 27, 2004 05:33 |