 |
 |
 |
|
|
|
[Sponsors] | ||||
[OpenFOAM.org] OpenFOAM-8 Compilation problem |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 29, 2022, 19:47
|
OpenFOAM-8 Compilation problem
|
#1 |
|
New Member
Lei Dai
Join Date: Feb 2020
Posts: 5
Rep Power: 7  |
Hi all,
Recently I am compiling OpenFOAM-8 with a 64-bit label. After I ran the following command, "./Allwmake -j4 2>&1" in the OpenFOAM-8 folder, it ran normally but the last 2 lines of my log file are: wmake transformPoints wmake zipUpMesh I am wondering if it is normal that it did not suggest a piece of message like "Compilation completed" or similar things. No error occurs and it just stopped there. Did it complete its compilation? Kind Regards, Lei |
|
|
|
|
|
| Tags |
| 64-bit, compile error, openfoam 8 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Frequently Asked Questions about Installing OpenFOAM | wyldckat | OpenFOAM Installation | 4 | December 16, 2025 09:40 |
| Getting Started with OpenFOAM | wyldckat | OpenFOAM | 26 | June 21, 2024 07:54 |
| [Commercial meshers] Problem OpenFOAM with mesh.msh imported from Gambit | David.C | OpenFOAM Meshing & Mesh Conversion | 1 | April 11, 2015 04:21 |
| Suggestion for a new sub-forum at OpenFOAM's Forum | wyldckat | Site Help, Feedback & Discussions | 20 | October 28, 2014 10:04 |
| New OpenFOAM Forum Structure | jola | OpenFOAM | 2 | October 19, 2011 07:55 |
Linear Mode
