|
[Sponsors] |
April 8, 2005, 16:54 |
Hello,
I installed OpenFOAM
|
#1 |
Senior Member
Billy
Join Date: Mar 2009
Posts: 167
Rep Power: 17 |
Hello,
I installed OpenFOAM 1.0.2 on two similiar systems. On the first everyhting went quite smoothly. However, during the second installation everything seemed to go fine until I tried to run FoamX or paraFoam. The error given was "segmentation fault" and both systems have the exact same software installed: Suse 9.2. Alhtough, I cannot start paraview or FoamX, the cases can be run from the terminal. Does anyone know what is wrong? Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Technical] Segmentation fault in map | msg30 | OpenFOAM Meshing & Mesh Conversion | 6 | March 27, 2008 10:49 |
segmentation fault | tipakorn | Siemens | 6 | July 31, 2006 07:56 |
segmentation fault | natesan | Siemens | 4 | January 12, 2004 08:51 |
Segmentation fault | Veebs | Siemens | 3 | June 4, 2002 22:17 |
Segmentation fault | Jose Sanchez | Siemens | 1 | December 16, 2001 08:13 |