[blockMesh] Mesh generation for a pipe with bendbends using blockMesh -- CFD Online Discussion Forums

May 4, 2007, 23:06	Mesh generation for a pipe with bendbends using blockMesh	#1
jaswi Senior Member Join Date: Mar 2009 Posts: 248 Rep Power: 18	Hello OpenFOAM users I am new to OpenFOAM. With the help of forum knowledgebase I have been able to install and create meshes for some simple geometries. My interest is to simulate flow in a pipe with bend. Is it possible to generate geometry + mesh using the blockMesh tool. Looking forward to suggestions Kind Regards Jaswi

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Too diffusive result on Delaunay type mesh for pipe	AlmostSurelyRob	OpenFOAM Running, Solving & CFD	7	October 8, 2018 13:34
State of mesh generation	Wandadars	Main CFD Forum	3	January 5, 2017 12:51
[ICEM] Using a hybrid mesh for a simple pipe	Udio_NT	ANSYS Meshing & Geometry	17	October 18, 2012 14:42
[ANSYS Meshing] Question about mesh generation learning	lnk	ANSYS Meshing & Geometry	2	July 7, 2012 06:45

All times are GMT -4. The time now is 07:11.