|
[Sponsors] |
September 13, 2019, 03:35 |
bad grid problem analysis
|
#1 |
New Member
John Wang
Join Date: Mar 2013
Posts: 8
Rep Power: 13 |
I am using snappyHexMesh generating grid but it always has some very strange grid at the geometry surface. Can any expert tell the reason and solution? Thanks.
|
|
September 14, 2019, 00:48 |
grid problem
|
#2 |
New Member
John Wang
Join Date: Mar 2013
Posts: 8
Rep Power: 13 |
I used snappyHexMesh to generate mesh. I got this result as attached that the snap function cannnot capture the geometry (blue parts) accurately. Can any expert tell the reason and solution? Thanks.
|
|
September 15, 2019, 07:48 |
|
#3 |
New Member
John Wang
Join Date: Mar 2013
Posts: 8
Rep Power: 13 |
The problem can be solved in some degree by adjust the snap controls setting.
|
|
September 15, 2019, 07:52 |
grid problem
|
#4 |
New Member
John Wang
Join Date: Mar 2013
Posts: 8
Rep Power: 13 |
I encountered a new problem that grid at some corners of the geometry has been very weird. Can any expert tell the reason and solution?
Thanks |
|
September 15, 2019, 07:53 |
|
#5 |
New Member
John Wang
Join Date: Mar 2013
Posts: 8
Rep Power: 13 |
||
September 17, 2019, 00:32 |
grid problem
|
#6 |
New Member
John Wang
Join Date: Mar 2013
Posts: 8
Rep Power: 13 |
I have finally fixed this problem.
it needs to be clarified that SnappyHexMesh does has the capability to snap even sharp corners of the geometry. The key parameters for this problem are: base mesh size nCellsBetweenLevels - 6 //solve bad grids at STL surface resolveFeatureAngle - 45 //value less than 90 could snap the perpendicular STL edge features{*.eMesh} //solve bad/rounded grids at STL surface edge refinementSurfaces{level(min,max)} //increase max value could help to snap edge more accurately in the same time keeping the STL surface grid size small nSmoothPatch - 3 // setting this value a little bit larger help solve bad grid problem but not too large which would distort other good grids nFeatureSnapIter - 5 //setting this value a little bit larger help solve bad grid problem but not too large which would increase iteration time significantly explicitFeatureSnap - true //would help snap features |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D Windturbine simulation in SU2 | k.vimalakanthan | SU2 | 15 | October 12, 2023 05:53 |
Fine/Turbo cannot open grid built by IGG, Configuration file problem? | wkjshon | Fidelity CFD | 6 | March 29, 2016 02:09 |
Thermal Analysis Problem | ChristianGermany | ANSYS | 0 | September 23, 2015 18:52 |
Problem with nozzle analysis | Aristine | Main CFD Forum | 0 | March 15, 2012 07:28 |
Problem with staggered grid on numerical simulation | gtr84 | Main CFD Forum | 1 | February 15, 2012 07:58 |