[Owais Shabbir]

Hi All,


I was trying to mesh two bodies over which the air will flow externally bounded by a box defined in blockMeshDict.

While meshing after the 2nd iteration of the surface refinement it shows the following error: (remaining error included in the photos)


Foam::error:rintStack(Foam::Ostream&) [1] ...[3] ...[3]... addr2line failed


Further Details: I have also run this with single processor and it just crashes down.

I have seen this problem on the community forum page describing it as bad maths and it is always linked to the solver not the snappyHexMesh. I would highly appreciate it if anyone could explain me why this error is generated and how to tackle this problem.

Thanks