[Salome] how can i get the mesh of interfaces between 2 sides?

bye bye my blue · November 13, 2016, 23:48

I cannot make the 2 interfaces which are located between 2 sides(red lines)
. To make it, I did partition total 3 sides. but an error occurred(about overlapping)

how can I get mesh???

khedar · November 14, 2016, 17:22

Please provide more info like, which software you are making this mesh? what kind of interface do you want to make(is it cyclicAMI/GGI interface?) etc..

bye bye my blue · November 15, 2016, 01:33

Quote:

Originally Posted by khedar

Please provide more info like, which software you are making this mesh? what kind of interface do you want to make(is it cyclicAMI/GGI interface?) etc..

i wanna make mesh with salome-meca 2015.2.LGPL

neither cyclicAMI nor GGI, i just make mesh on interface(RED LINE which is overlapped back and front).

REDLine shows overlapped side between 2 sides.
(when I make mesh in salome, the message "NgException at Volume meshing: Stop meshing since boundary mesh is overlapping." occurred.)

but i want make mesh between 2sides

can salome make mesh overlapped side between 2 sides?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[snappyHexMesh] Layers:problem with curvature	giulio.topazio	OpenFOAM Meshing & Mesh Conversion	10	August 22, 2012 09:03
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

November 14, 2016, 17:22		#2
khedar Senior Member khedar Join Date: Oct 2016 Posts: 111 Rep Power: 9	Please provide more info like, which software you are making this mesh? what kind of interface do you want to make(is it cyclicAMI/GGI interface?) etc..