|
[Sponsors] |
[Other] cyclicAMI for non-matching interfaces |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 9, 2015, 04:48 |
cyclicAMI for non-matching interfaces
|
#1 |
New Member
Hannes Grimm-Strele
Join Date: Sep 2015
Posts: 7
Rep Power: 10 |
Dear all,
I have a very simple test case here: just two structured blocks with different number of points as shown on the attached picture. I used the cyclicAMI type to define the interface. P1 { type cyclicAMI; nFaces 64; startFace 4528; matchTolerance 0.001; transform noOrdering; neighbourPatch P2; } (analogously for the other side P2). Now, checkMesh tells me *Number of regions: 2 The mesh has multiple regions which are not connected by any face. <<Writing region information to "0/cellToRegion" <<Writing region 0 with 512 cells to cellSet region0 <<Writing region 1 with 1152 cells to cellSet region1 Is this a warning I have to worry about? Is my general approach towards non-matching interfaces valid at all? Thank you for your help! |
|
October 12, 2015, 05:59 |
|
#2 |
Senior Member
|
Hi,
I guess this should work. You may want to check that the regions are on either side of the cyclicAMI interface in ParaView (use the cellToRegion variable). Due to the non-conformal interface there is no direct connection between the regions, which would indeed trigger this warning. Regards, Tom |
|
October 13, 2015, 07:49 |
|
#3 |
New Member
Hannes Grimm-Strele
Join Date: Sep 2015
Posts: 7
Rep Power: 10 |
A simple test simulation runs nicely, I just was a bit worried by the warning. Thanks for your answer and the explanation!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Using createPatch and cyclicAMI in FOAM Extend to create periodicbox | manuc | OpenFOAM Running, Solving & CFD | 1 | April 12, 2022 11:36 |
Flux not conserved in cyclicAMI interfaces if areas are different | jherb | OpenFOAM Programming & Development | 1 | January 23, 2019 10:22 |
cyclicAMI - kOmegaSST - divergence issue | cyln | OpenFOAM Running, Solving & CFD | 1 | October 5, 2018 10:06 |
cyclic / cyclicAMI boundary conditon - ICEM Mesh | cyln | OpenFOAM Running, Solving & CFD | 0 | November 7, 2017 15:26 |
cyclicAMI for non matching geometry? | tms | OpenFOAM Running, Solving & CFD | 7 | September 3, 2012 06:47 |