|
[Sponsors] |
August 30, 2017, 17:14 |
Wall functions on small models
|
#1 |
Senior Member
Nejc
Join Date: Feb 2017
Location: Slovenia
Posts: 196
Rep Power: 9 |
Hello!
If I wanted to mesh an impeller that is very small and use wall functions on that mesh, the solver would explode because I can't provide boundary layer thickness of 30y+ or more. I can dump wall functions altogether and model flow near the wall but then it seems impossible to connect rotating and stationary parts of the mesh with AMI/ACMI because cells near the wall get thin enough to cause trouble with neighboring patches. Any ideas how to deal with this or at least where to start? Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Enhanced Wall Treatment | paduchev | FLUENT | 24 | January 8, 2018 11:55 |
Centrifugal fan-reverse flow in outlet lesds to a mass in flow field | xiexing | CFX | 3 | March 29, 2017 10:00 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
wall functions for RAS models | Epf | OpenFOAM Pre-Processing | 3 | April 8, 2010 11:14 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |