|
[Sponsors] |
[snappyHexMesh] snappyHexMesh on 1.7.1 and 2.1.0 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 3, 2012, 11:50 |
snappyHexMesh on 1.7.1 and 2.1.0
|
#1 |
Senior Member
Andrea Ferrari
Join Date: Dec 2010
Posts: 319
Rep Power: 16 |
Hi all,
What are the differences between the old snappyHexMesh (OF 1.7) and the the new one (OF 2.1). I meshed the same geometry with both versions, using the same dictionary and obtaining different mesh: snappy of OF 2.1.0 Mesh stats points: 5756460 internal points: 0 faces: 11189366 internal faces: 5292421 cells: 2767077 boundary patches: 7 point zones: 0 face zones: 0 cell zones: 0 Overall number of cells of each type: hexahedra: 2646402 prisms: 120675 wedges: 0 pyramids: 0 tet wedges: 0 tetrahedra: 0 polyhedra: 0 snappy on OF 1.7.1 Mesh stats points: 5997810 internal points: 0 faces: 11310041 internal faces: 5292421 cells: 2767077 boundary patches: 7 point zones: 0 face zones: 0 cell zones: 0 Overall number of cells of each type: hexahedra: 2767077 prisms: 0 wedges: 0 pyramids: 0 tet wedges: 0 tetrahedra: 0 polyhedra: 0 The total number of cells is the same but in OF 1.7.1 i have only hexa (some cells were not exactly hex, but they were a little bit distorted) while in OF 2.1 i got also some prisms cells. Since i think that working with hex is always better how can i reproduce the same hex-mesh on OF 2.1? How can I avoid prisms? thanks andrea |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh in Parallel problem | swifty | OpenFOAM Meshing & Mesh Conversion | 10 | November 6, 2015 04:40 |
[snappyHexMesh] Error with a turbine mesh with SnappyHexMesh | DOliveira | OpenFOAM Meshing & Mesh Conversion | 1 | July 16, 2015 08:02 |
[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer | Sunxing | OpenFOAM Meshing & Mesh Conversion | 9 | September 20, 2014 09:30 |
Error in meshing a Ship hull using snappyhexmesh | Sachin m | OpenFOAM Pre-Processing | 1 | August 27, 2014 23:27 |
OpenFOAM 2.2.0 and 2.1.0 side by side errors | Neraste | OpenFOAM Installation | 2 | June 12, 2013 04:55 |