|
[Sponsors] |
[mesh manipulation] reconstruct addedCells set from parallel meshing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 21, 2012, 03:23 |
reconstruct addedCells set from parallel meshing
|
#1 |
Senior Member
Eloïse
Join Date: Jul 2012
Location: Trondheim, Norway
Posts: 113
Rep Power: 13 |
Hi,
I am meshing in parallel a geometry with viscous layers. I would like to visualize the addedCells set in ParaView (with the command foamToVTK -cellSet addedCells) but this set is not reconstructed with the command reconstructParMesh. Does anyone knows how to reconstruct it? Remarks: - If I run the meshing in serial, the addedCells set is present in 3/polymesh/sets - If I run the mesh in parallel, the addedCells set is present in processor**/3/polymesh/sets but not in the reconstructed mesh 3/polymesh/sets Thanks, Eloïse |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX parallel set up hangs after calculations finished | jgross | CFX | 8 | January 10, 2020 06:38 |
[ANSYS Meshing] Meshing parallel | Andrea159357 | ANSYS Meshing & Geometry | 0 | January 3, 2019 18:36 |
Error running openfoam in parallel | fede32 | OpenFOAM Programming & Development | 5 | October 4, 2018 16:38 |
[ANSYS Meshing] Ansys 15 Parallel Meshing? | robmuggleton | ANSYS Meshing & Geometry | 1 | March 6, 2014 10:08 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |