|
[Sponsors] |
[blockMesh] Number of edges not aligned with or perpendicular to non-empty directions |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Alex Flaminio
Join Date: Feb 2013
Posts: 3
Rep Power: 14 ![]() |
Hey all,
I'm trying to model a wind tunnel section with a flat plate going across from side to side, blockMesh works but in checkMesh I get the folowing message: "Number of edges not aligned with or perpendicular to non-empty directions" Does anyone know which changes I could try to make to fix this problem? Thanks a lot, Alex |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Equal decomposition of cylindrical fluid domain | Sean95 | OpenFOAM Meshing & Mesh Conversion | 3 | February 12, 2019 03:34 |
[blockMesh] blockMesh "Number of edges not aligned with or perpendicular to non-empty direction" | DuarteMagalhaes | OpenFOAM Meshing & Mesh Conversion | 9 | July 2, 2018 01:04 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |